EAW CAZ800 Instruction Manual download pdf (Page 14)

14 – SMS1990

Mechanical Installation

Mounting the clip-ﬁt brackets to the wall:

a. Mount the wall bracket to the desired

surface, in this vertical orientation only.

Note that the bracket has two mounting

holes with vertical spacing that allows

them to be used with a standard wall J-

box.

Two screws are supplied for securing the

wall bracket to a J-box. Install the shorter

6-32 screw in the top hole of the J-box,

and the longer screw in the bottom. Only

screw them in by a few threads initially,

then place the clip-ﬁt bracket over the

screws through the key-hole slots in the

bracket as shown. Tighten the screws once

the bracket is securely in place.

Rotating the loudspeaker’s input section

(if required):

The SMS1990 loudspeaker can be mounted vertically (as

shown) onto the clip-ﬁt bracket, or horizontally. If you want

to change the orientation, follow these steps:

a. Remove the four screws holding the circular input

section in place.

b. Pull out the input section by approximately half an

inch, and rotate it through no more than 90 degrees.

c. Secure the input section into its new position with the four screws.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

EAW CAZ800 Instruction Manual Page 14