EAW UX8800 Owner's Manual download pdf (Page 18)

4.4.6 CONNECTING MULTIPLE PROCESSORS TO AN ETHERNET NETWORK

Use the front panel Ethernet port and a standard Ethernet cable to

connect each processor to a 10, 10/100, or 100 Mbps Ethernet hub,

switch, or router on a network.

4.4.7 CONNECTING MULTIPLE PROCESSORS TO AN ETHERNET AND U-NET NETWORK

Use the front panel Ethernet port and a standard Ethernet

cable to connect processors to a 10, 10/100, or 100 Mbps

Ethernet hub, switch, or router on the network. Connect

additional processors to the Ethernet hub, switch, or

router or connect additional processors to the system

using the U-Net ports as in Section 4.4.4.

NOTE: Audio signals may also be routed between

processors over the same U-Net cables by assigning

Input Channel and Output Channel signals to U-Net

channels.

4.4.8 SOFTWARE INSTALLATION -- EAWPILOT

EAWPilot requires an IBM compatible PC equipped as follows:

Operating System: Windows Vista, XP, 2000, NT, ME, or Windows 98

I/O: Ethernet network interface card (NIC) 10, 10/100, or 100 Mbps

The latest EAWPilot can be downloaded from the EAW web site: www.eaw.com. Go to the “Downloads”

page or contact the factory and a copy will be sent to you on a CD-ROM. Once installed and with the

computer connected to the UX8800, open EAWPilot by clicking on EAWPilot in the

Start/Programs/EAW/EAWPilot.

Page 8

EAWP ILOT

UX8800 "A"

U-Net

Ethernet

Hub or Switch

To additional

UX8800(s)

EAWP ILOT

UX8800 "A"

U-Net

UX8800 "C"

UX8800 "B"

UX8800 "D"

EthernetEthernet

Ethernet

Ethernet Hub or Switch

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

No comments

EAW UX8800 Owner's Manual Page 18