EAW UX8800 Owner's Manual download pdf (Page 36)

APPENDIX

A Greybox Information

PURPOSE FOR GREYBOX FILES

In Loudspeaker Processor mode, the UX8800 allows loading files with factory-determined processing for

specific loudspeaker models and arrays. This processing includes equalization, crossovers, high and/or

low pass filtering, signal delay, and level control. In addition, files with Gunness Focusing also include

proprietary processing invented by EAW specifically for correction of inherent loudspeaker anomalies.

Often, audio system designers, technicians, or end-users attempt to create loudspeaker processing from

scratch using one of the several, excellent measurement systems publicly available. However, the systems

and methods cannot duplicate what is involved for EAW engineers to create Greybox processor settings:

• Loudspeaker data far greater in quantity, types, precision, and accuracy (especially polar data).

• Use of proprietary analysis tools developed specifically for loudspeaker data.

• Use of proprietary Gunness Focusing algorithms for the processing.

•

Extensive listening tests performed by a wider range of people over a much greater time period

and under a much greater range of conditions.

• Controlled, laboratory conditions.

• Extensive knowledge in the application of loudspeaker data analysis and signal processing.

B System Processor Mode Processing

In System Processor mode, the UX8800 may appear similar to other digital signal processors. However, the

processing algorithms used in the UX8800 differ from the normal, “textbook” algorithms used in digital

processors. EAW developed new algorithms specifically tailored for digital audio processor hardware.

FILTER RESPONSE EXAMPLE

The accuracy and precision of the UX8800 filter responses can be compared to those using textbook

algorithms. When applied to audio processing hardware, the latter do not provide textbook responses. The

two graphs compare the results of EAW’s processing algorithms and standard “textbook” algorithms as

used in well-accepted, digital signal processors. The frequency responses and phase response are for the

UX8800 (lower curves) and a non-EAW processor (upper curves). The settings were two filters set for a 5

dB boost, 1 octave bandwidth (Q = 1), at frequencies of 1 kHz and 15 kHz. There are several things to note:

1. The upper curve is the upper curve becasuse its filter skirts extend somewhat beyond that of

an ideal filter. In this case, the lower -3 dB point for the 1 kHz filter is actually over an octave

below the filter frequency. The EAW response follows the response of an ideal filter.

2. The shapes of both the 1 kHz and 15 kHz filter frequency and phase responses are different for

the non-EAW processor. In contrast, the frequency and phase response shapes of the two EAW

filters are quite similar. When overlayed, they prove to be virtually identical.

3. Because of the difference in two non-EAW filter shapes, the response of the filters overlaps too

much, resulting in an excessive boost in the 5 kHz to 10 kHz region.

Frequency Responses Phase Responses

Page 26

1 2 ... 31 32 33 34 35 36 37 38 39 40

No comments

EAW UX8800 Owner's Manual Page 36