Eaw D S A 2 3 0 User Manual download pdf (Page 29)

5.6 Initial Set-Up

5.6.1 VERIFY LOUDSPEAKER ORIENTATION AND POSITION

Using the DSAPilot, and with communications established with the

loudspeakers, click on each loudspeaker in DSAPilot. The LED in

both the DSAPilot graphic and on the actual loudspeaker will

illuminate. Ensure that the physical orientation and position of

each loudspeaker corresponds to that shown in the DSAPilot graphic.

See the DSAPilot help file for further information.

CAUTION: Incorrect orientation or cluster position will result in poor

to unusable performance.

5.7 Acoustical Installation

Adjustment of the signal processing and thus the acoustical performance

for each DSA Cluster is accomplished using the DSAPilot program.

Complete instructions for its use can be found in the DSAPilot Help file.

These are the basic tasks that need to be done using the DSAPilot:

1. Select each cluster configuration used in the system design

2. Assign the installed clusters to those selected in the DSAPilot

3. Set the Steering parameters for each cluster

4. Configure the audio input routing for each cluster

5. Set the user-adjustable gain, EQ, compression, or signal delay for

the inputs

6. Set the desired Power Saving operation

7. Save the final signal processing settings for the system to a file

LED INDICATOR

Figure 5.6 Identification LED

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

No comments

Eaw D S A 2 3 0 User Manual Page 29