EAW UX3600 Owner's Manual download pdf (Page 13)

From the EQ menu press the right arrow key twice to step through the Parametric EQ In/Out

selection field. The filter number will appear on the upper right corner of the LCD (1 through

10). Use the up and down arrows to set the Type, BW, Freq, Gain, and Flt for any given filter.

To advance to another filter press and hold the right or left arrow key for at least 2 seconds.

When finished press OK.

5 . 5 D e l a y

Use the DELAY function to set Input Channel and Output Channel signal delay by selecting

the A to C or 1 to 6 buttons.

INPUT DELAY:

To change the DELAY parameter use the OK button to select Delay and

use the left or right arrow buttons to choose millisecond (ms) or distance input

and use the OK button to select. Use the up or down arrow buttons to set delay.

Press OK when finished to enter selected delay.

When a Greybox has been loaded changes made to one Greybox output leg will be applied to

all output legs associated with the same Greybox.

5 . 6 M e n u

Use the MENU function to setup remaining channel specific parameters and global settings

for the processor.

5.6.1 CHANNEL SETUP

Use the Channel Setup submenu to select Sources and name Input Channels and Output

Channels. Use this feature to view Greybox type, enter amplifier information into Greybox limiters,

and set listener distance into Output Channels tied to a Greybox.

INPUT SOURCE:

Each input can be fed from one or the sum of two combined Analog inputs. To

change Source use the up and down arrow buttons to choose Source 1 or

Source 2. Use the OK button to select and use the up or down arrow button

to set one of the three Analog inputs. Press OK when finished to enter

selected Source.

OUTPUT SOURCE

(WITHOUT GREYBOX):

Each Output Channel can be fed from one of the Input Channels and loaded

with a Greybox from the processors memory. To change Source use the up

and down arrow buttons. Use the OK button to select and use the up or down

arrow button to set one of the three Input Channels. Press O when finished

to enter selected Source. The type of Output Source is always System

Processing when not tied to a Greybox.

OUTPUT SOURCE

(LOADING A GREYBOX FROM INTERNAL MEMORY):

If a Greybox has been stored to the processors memory from EAWPilot it can

be used to drive an output by using the up and down arrow keys to choose

Type. Use the OK button to select and the up and down arrows to choose a

Greybox. Greyboxes are then configured through the following steps:

1. Select an Input Source for the Greybox.

2. Choose Yes to reset Input DSP for use with a Greybox or No to abort.

3. Assuming you chose Yes, set a High Pass Filter Frequency for the Greybox.

4. Choose an output for the designated Greybox leg (a leg refers to a bandpass in a

multi-amp Greybox or full range output of a single-amp Greybox). The leg will be

displayed under the Output Channel Selection on the display.

Page 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

EAW UX3600 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Processors EAW UX3600