Eaw DSA250 & DSA230 User Manual download pdf (Page 27)

5.5.8 ENCLOSURE BRACKET INSTALLATION

Insert each supplied Enclosure Bracket into its slot near each end of the

enclosure, verifying the proper orientation of the enclosure. Insert a

supplied 3/8-16 x 2 in Enclosure Bracket Bolt with its lock washer into

each bracket bolt hole in the enclosure. Thread each bolt into the weld

nut on its Enclosure Bracket and hand-tighten.

CAUTION: Make sure the brackets are installed so the enclosure

orientation will be correct when the enclosure is mounted.

5.5.9 ENCLOSURE INSTALLATION

Lift the enclosure onto the structure-mounted Wall Brackets

DANGER: It is recommended that lifting the enclosure in place be

performed by at least two people to prevent it from falling during its

installation and causing possible equipment damage, injury, or death.

CAUTION: For DSA Clusters with two or more loudspeakers mounted

one over the other, it is recommended to make all cable connections

before lifting the loudspeakers onto the wall brackets. See Sections

5.2 through 5.6. Once the loudspeakers are mounted, access to the

connectors may be difficult.

IMPORTANT: When installing loudspeakers mounted vertically end to

end, install the lower loudspeaker first.

2X ENCLOSURE

MOUNTING

BRACKET

P/N 0006118

2X 3/8-16 X 2 LG

HEX HEAD SCREWS

& LOCK WASHERS

Figure 5.5.8 Enclosure Bracket Installation

2X WALL

MOUNTING

BRACKET

P/N 0006119

Figure 5.5.9a Enclosure Installation

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

No comments

Eaw DSA250 & DSA230 User Manual Page 27