EAW DX810 Instruction Manual download pdf (Page 5)

DX810 – 5

A B LOCK

MODE

POWER

COMM PORT

BA MASTER

DX810 DIGITAL MIXER

REMOTE BUS

RECORD

OUTPUTS

LOGIC I/O

TRIM

URING DATE

COMM PORT

12345678

LINE

MIC

30dB +30dB

PHANTOM POWER

48V DC

12 1 +5V

11G1

–

INPUTS

OUTPUTS

J I H G

C D E F

•

–

FRONT PANEL FEATURES

Note: The front panel controls only apply to the A

and B outputs. Outputs C through J are controlled

with the DX-810-PC software interface.

INPUT UP/DOWN BUTTONS

Use these buttons to adjust the mix level for each

input channel.

INPUT LED DISPLAY

This indicates the signal level after the mic preamp

stage, just after the A/D converter, but prior to any

digital signal processing. When any input UP/

DOWN button is pressed, all the meters (except

EQ) switch from level metering to level setting

indication. After five seconds, the meters switch

back to normal peak program metering (PPM).

When the 10 and 7 LEDs are both lit, the gain is set

to unity (0 dB).

EQ LO/HI UP/DOWN BUTTONS

These buttons are disabled in the DX810 (they are

for DX8 use only).

EQ LED DISPLAY

This display is disabled in the DX810 (it is for DX8

use only).

MASTER A/B UP/DOWN BUTTONS

These buttons adjust the output level for the A and

B output buses.

MASTER OUTPUT LED DISPLAY

This indicates the signal level after the digital signal

processing and MASTER A and B gain stage, just

prior to the D/A converter. When any MASTER UP/

DOWN button is pressed, all the meters switch

from level metering to level setting indication. After

five seconds, the meters switch back to normal

peak program metering (PPM).

MODE

This switch changes the front panel operation

between Bus A and Bus B operation. In addition,

the LOCK position disables the front panel controls

to prevent unauthorized changes to the settings. A

security code must be entered to enable the front

panel controls when the DX810 is locked. See page

13 for more information on locking and unlocking

the DX810.

COMM PORT

This is an RS-232 port on a 9-pin D-Sub

connector. It connects to a personal

computer or other compatible control

system for external control of the DX810

settings. A second COMM port on the rear

panel duplicates this function, for

permanent connection to an installed

controller.

POWER

Use the POWER switch to turn the DX810

on and off.

REAR PANEL FEATURES

INPUTS 1-8

Each of the eight analog inputs has

separate balanced mic and line input

connectors that use XDR mic preamps.

These are 3-pin Phoenix-type connectors.

Use either the MIC or LINE input, but only

one can be used per channel.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comments to this Manuals

No comments

EAW DX810 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Processors EAW DX810