Eaw UX8800 User Manual download pdf (Page 22)

Page 12

6 OPERATION - SYSTEM PROCESSOR MODE

6.1 Introduction

System Processor mode configures the processor for standard, digital signal processing functions. These

functions consist of Input Channel and Output Channel processing that includes equalization filters, signal

delay, polarity, gain, crossover filters, limiting, and high/low-pass filters. All parameters are user

accessible and user adjustable.

6.2 Select System Processor Mode

1. Select the UTIL function.

2. Scroll down to and select: Mode

3. Select: System Processor. This will reboot the processor and reset all parameters to their default

settings for this mode.

6.3 Signal Routing

In order to pass signal, these tasks must be completed as detailed in the sections listed.

1. Select the type of input signal connected to the XLR input connectors (5.3.3).

2. Assign one or two sources (input connector signals) to each input channel (6.4.1).

3. Assign a source (an input channel) to each output channel (6.5.1).

6.4 CH (Input Channels A to D)

Use the CH function to set the parameters for Input Channels Ato D by selecting the Ato D buttons.

6.4.1 SRC - SOURCE 1 / SOURCE 2

Select either a single source or a sum of two sources. The same source can be selected for multiple Input

Channels. The source choices available depend on the configuration of the Input Channels as set in the

UTIL menu.

None

Analog A / AES A CH 1

Analog B / AES A CH 2

Analog C / AES B CH 1

Analog D / AES B CH 2

U-Net 1 to 32

6.4.2 CHANNEL NAME

Enter a name for the input channel, up to 16 alphanumeric characters.

6.4.3 U-NET OUT ASSIGN

Assign the summed, unprocessed sources to a U-Net output channel. This is useful for daisy-chaining a

single analog or AES source signal to multiple UX8800 units.

6.5 CH (Output Channels 1 to 8)

Use the CH function to set the parameters for Output Channels 1 to 8 by selecting the 1 to 8 buttons.

6.5.1 SOURCE SELECT

Select one of the Input Channels as a source for the Output Channel. The same Input Channel can be the

source for multiple Output Channels.

None

Input Channel A

Input Channel B

Input Channel C

Input Channel D

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments

Eaw UX8800 User Manual Page 22

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Eaw UX8800